The Kennametal T045 is a tungsten carbide angle blast nozzle with three outlets set at 45°. It reaches the surfaces a straight nozzle can't: the inside of pipe, the back of flanges and stiffeners, and the gaps in lattice and box-section steelwork. The three outlets face different ways, so each pass covers more of a pipe bore or recess than a single-outlet angle nozzle. You also stop relying on ricochet to reach hidden faces, which wastes abrasive and time.
Air Supply Requirements
Three outlets use roughly three times the air and abrasive of a single nozzle with the same bore. A 3/8" triple outlet nozzle, for example, needs about as much air as a single 5/8" nozzle. Choose the bore your compressor can support, select the technical data sheet in downloads tab.
*Based on Kennametal's air chart for a single nozzle at 100 psi (6.9 bar), multiplied by three. Compressor sizes include the 50% spare capacity Kennametal recommends, so the nozzle keeps working as it wears. Figures are approximate.
Liner Specification and Wear-life
Tungsten carbide is strong and tough, well suited for site work, where nozzles get knocked about. Kennametal estimates its tungsten carbide nozzles last roughly 300–400 hours with slag abrasives and 500–800 hours with steel shot or grit. With aluminium oxide that drops to 20–40 hours.
Routine Inspection and Maintenance Recommendations
- Fit a new nozzle washer with each nozzle and check it every 10–20 hours of blasting. A worn washer lets abrasive eat into the nozzle entry.
- Check all three bores with a nozzle orifice gauge. Wear causes pressure loss, and every 1 psi lost costs about 1.5% of your production rate.
- Check the pressure at the nozzle with a needle pressure gauge.
- Never use a cracked nozzle. If the liner breaks, the blast stream can come out of the side of the nozzle towards the operator.